 |
Easy
to program memory banks
Managing 1000 memories is easy when you use the free
software available from the Alinco website and the optional
ERW-4C cable (USB/Serial conversion cable usable with ERW-4C for
USB connections) to expand your own bank-partitions from
standard 10 up to 50!
(Note: This feature is accessible only with using the
free-software and allows you to freely set up bank partitions up
to 50 banks within the available 1000 memory channels.)
|
|
Pre-set
bands make operation easy
AM/FM and TV audio bands have been pre-set to make it easy to
enjoy the DJ-X7E right from the start.
|
|
Five
scan modes
Five scan modes are available including preset frequencies, VFO,
memory scan, programmed scan or tone scan to search for unknown
CTCSS tones. The Timed/busy modes are selectable on all modes
except the tone scan mode.
|
|
Power
options keep you in control
The DJ-X7 comes with a standard adapter that charges the Lithium
ion battery AT THE SAME TIME it powers the radio with AC power.
So, you can listen while the unit is charging. Plus, the
long-lasting, partially rechargeable lithium ion battery
delivers approximately 19 hours of operating time.
(AC adapter may cause slight noise to the receiving audio on
some frequencies. The operating time may vary depending on
settings such as audio-volume level, battery-save status etc.) |
|
Receiver
range: 0.100 - 1299.995MHz continuous
(USA T-version cellular-band blocked 824.000-849.995MHz,
869.000-894.995MHz) |
|
Mode:
A3E (AM) / F3E (FM,WFM) |
|
Antenna
Impedance: 50 ohms unbalanced / SMA-port |
|
Operating
battery voltage: DC3.7V (external DC port DC3.7V-6.0V) |
|
Current
consumption: Approx. 90mA average/Approx. 65mA stand-by/Approx
22mA battery-save on |
|
Frequency
stability: -7 to +3ppm at -10c to +60c |
|
Dimension
without projection: 58(W) x 96(H) x 14.5(D) mm |
|
Weight:103g
antenna/battery inclusive |
|
Receiver:
Triple-conv. Super-heterodyne (NFM,AM) / Double-conv.
Super-heterodyne (WFM)
1st IF: 243.95MHz
2nd IF: 39.15MHz (NFM,AM) 10.70MHz (WFM)
3rd IF: 450KHz (NFM,AM) |
|
Sensitivity:
Typical values in the bands, not the minimum guaranteed values
FM / 30 to 470MHz : 12dBu (0.25uV), 470MHz or higher 6dBu
(0.5uV) 12dBSINAD
WFM / 76-470MHz : 2dBu (0.8uV), 470MHz or higher 9dBu (2.8uV)
12dBSINAD
AM / 0.1-50MHz : 0dBu (1.0uV), 50MHz 8dBu (0.4uV) 10dBS/N |
|
Selectivity:
6dB 12kHz or more, 60dB 35kHz or less (NFM,AM), 6dB 130kHz or
more, 60dB 300kHz or more (WFM) |
|
Audio
Output power: Max 100mW or more (8ohms) |
|
Typical
operating time: Approx. 19 hours with EBP58N (RX 1: Stand-by
4 BS-on) |
